Dimplex / Products / Heat pumps / Brine-to-Water
In order to guarantee the minimum compressor runtimes the circulated heating volume should be such that the heating volume is circulated no more than 10 times per hour. This can be ensured either by a buffer tank or by other suitable means.
In buildings with underfloor heating systems without individual room regulation this requirement can usually be fulfilled without a buffer tank.
Order reference: WWSP 229E
Nominal capacity 227 l, in brine-to-water heat pump design to enable space-saving installation on the built-under domestic hot water cylinder, bare-tube heat exchanger (internal), steel cylinder (special inside enamelling) with protection anode, polyurethane insulation with minimum standby losses; integrated temperature sensor for connection to the heat pump manager, colour: white, brown red design screen.
Order reference: VSW 229
Hose set for easy connection of the compact brine-to-water heat pump and the built-under domestic hot water cylinder to the heating system. Consists of 2 corrugated stainless steel tubes with high and low temperature insulation, 2 elbow unions with manual breather and an installation option for the domestic hot water circulating pump (pump not included in the scope of supply).
Print
Up